Difference between revisions of "TTP223 Touch Sensor Module"

From Wiki
Jump to: navigation, search
(Created page with "='''Introduction'''= File:Touch-2.jpgFile:Touch-1.jpg<br> The capacitive inching touch switch module is based on touch monitoring IC (TTP223B). Generally, it outputs...")
 
(No difference)

Latest revision as of 02:06, 5 September 2019

Introduction

Touch-2.jpgTouch-1.jpg

The capacitive inching touch switch module is based on touch monitoring IC (TTP223B). Generally, it outputs low level with low-power consumption mode. If there is a touch around the sensing area, the module will output high level; accordingly, the mode will be switched to fast mode. With your finger removing from the sensing area for 12s, the mode will be switched back to low-power consumption mode.

Main Features

  • Operating voltage: 2~5.5V DC;
  • Inching Mode: Low level in initial state, high level with a touch, low level without touching (similar to soft-touch button);
  • Low-power consumption;
  • Double-sided touch panel, a great substitute for soft-touch button;
  • 4 × M2 screw mounting hole;
  • Easy-mounting.

Introduction of Pins

  • GND: Ground
  • VCC: 2~5.5V DC
  • SIG: Digit Signal Output Pin

For Arduino

Using Steps
Step 1: Connect the circuit.
Touch-3.jpg

Touch-4.jpg

Step 2: Copy the following codes and paste them in Arduino.

//Arduino Sample Code
#define TouchSensor 7 // Pin 7 for capactitive touch sensor
void setup()
{
  pinMode(TouchSensor,INPUT);
  Serial.begin(9600); //Set serial baud rate to 9600 bps
}
void loop()
{
  Serial.println(digitalRead(TouchSensor));//Print the Pin 7 value to serial port
  delay(200);
}

The codes above are used to acquire the signal of the touch sensor via the digital pin 7 and to output the signals into the computer via serial port. To observe the consequence, we can use serial port monitor.

Touch-5.jpg