2-Channel High Level Trigger Relay

Introduction

This is a 2-channel HIGH level trigger relay; apply to Arduino and Raspberry Pi. Relays are suitable for driving high power electronic devices such as lights, electric fans and air condition. A relay can be used to control high voltages with a low voltage by connecting it to an MCU.

Principle

Sending a HIGH level to SIG; the NPN transistor is energized and the coil of the relay is electrified. Thus, the normally open contact of the relay is closed, while the normally closed contact of the relay will be open. Send a LOW level to SIG; the transistor will be de-energized and the relay will restore to the initial state.

The schematic of the relay module is shown as following:

Principle of relay

See the picture here : A is an electromagnet, B armature, C spring, D moving contact, and E fixed contacts. There are two fixed contacts, a normally closed and a normally open. When the coil is not energized, the normally open contact is the one that is off, while the normally closed one is the other that is on. 

Add a certain voltage to the coil and some currents will pass through the coil thus generating the electromagnetic effect. So the armature overcomes the tension of the spring and is attracted to the core, thus closing the moving contact of the armature and the normally open contact (or you may say releasing the former and the normally closed contact). After the coil is de-energized, the electromagnetic force disappears and the armature moves back to the original position, releasing the moving contact and normally closed contact. The closing and releasing of the contacts results in power on and off of the circuit.  

Features

Support control of 10A 30V DC and 10A 250V AC signals

Working voltage: 5V;

PCB size: 5.6 x 4.3 cm

With power light and signal output indicator 

Application

The module can be used as a development module on an MCU or for control of household appliances.

2_channel_relay py_Code
2_channel_high_relay for Arduino
Relay_datasheet