Difference between revisions of "MPU6050 Module"
From Wiki
| Line 2: | Line 2: | ||
[[File:mpu6050.png]]<br> | [[File:mpu6050.png]]<br> | ||
The MPU-6050 is the world’s first and only 6-axis motion tracking devices designed for the low power, low cost, and high performance requirements of smartphones, tablets and wearable sensors.<br> | The MPU-6050 is the world’s first and only 6-axis motion tracking devices designed for the low power, low cost, and high performance requirements of smartphones, tablets and wearable sensors.<br> | ||
| + | =='''Experimental Procedures'''== | ||
| + | ===Step 1: Connect the circuit=== | ||
| + | See the following table for connection between the I2C LCD2004 and the SunFounder Uno board:<br> | ||
| + | [[File:Fdfds.png]] <br> | ||
| + | <center> | ||
| + | {| border="1" class="wikitable" | ||
| + | |- | ||
| + | ! scope="col" | MPU6050 | ||
| + | ! scope="col" | SunFounder uno Board | ||
| + | |- | ||
| + | |align="center"|GND | ||
| + | |align="center"|GND | ||
| + | |- | ||
| + | |align="center"|VCC | ||
| + | |align="center"|5V | ||
| + | |- | ||
| + | |align="center"|SDA | ||
| + | |align="center"|A4 /pin 20 mega2560 | ||
| + | |- | ||
| + | |align="center"|SCL | ||
| + | |align="center"|A5 /pin 21 mega2560 | ||
| + | |} | ||
| + | </center> | ||
| + | |||
| + | ===Step 2:Add library=== | ||
=='''Resource'''== | =='''Resource'''== | ||
[ Test Experiment for Arduino][[File:LINK.jpg]]<br> | [ Test Experiment for Arduino][[File:LINK.jpg]]<br> | ||
[https://www.sunfounder.com/learn/sensor-kit-v2-0-for-raspberry-pi-b-plus/lesson-32-mpu6050-gyro-acceleration-sensor-sensor-kit-v2-0-for-b-plus.html Test Experiment for Raspberry Pi][[File:LINK.jpg]] | [https://www.sunfounder.com/learn/sensor-kit-v2-0-for-raspberry-pi-b-plus/lesson-32-mpu6050-gyro-acceleration-sensor-sensor-kit-v2-0-for-b-plus.html Test Experiment for Raspberry Pi][[File:LINK.jpg]] | ||
Revision as of 01:46, 28 August 2017
Contents
Introduction
The MPU-6050 is the world’s first and only 6-axis motion tracking devices designed for the low power, low cost, and high performance requirements of smartphones, tablets and wearable sensors.
Experimental Procedures
Step 1: Connect the circuit
See the following table for connection between the I2C LCD2004 and the SunFounder Uno board:
| MPU6050 | SunFounder uno Board |
|---|---|
| GND | GND |
| VCC | 5V |
| SDA | A4 /pin 20 mega2560 |
| SCL | A5 /pin 21 mega2560 |
Step 2:Add library
Resource
[ Test Experiment for Arduino]
Test Experiment for Raspberry Pi
