QMC5883L

From Wiki
Revision as of 03:39, 8 January 2018 by Root (Talk | contribs) (Resource)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

Introduction

Hmc1.jpg

The module includes a state-of-the-art, high-resolution QMC5883X series magneto-resistive sensor, plus an ASIC containing amplification, automatic degaussing strap drivers, offset cancellation, and a 12-bit ADC that enables 1° to 2° compass heading accuracy. The I2C serial bus allows for easy interface.

Features

(1)The Honeywell QMC5883L is a surface-mount, multi-chip module designed for low-field magnetic sensing with a digital interface for applications such as low cost compassing and magnetometry

(2)The 12-Bit ADC coupled with low noise AMR sensors achieves 5 milli-gauss field resolution in ±8 gauss fields

(3)Low voltage operations and low power consumption; supports built-in self-test

(4)Built-in strap drive circuits, I2C digital interface, wide magnetic field range (+/-8 oe)

(5)Working voltage: 3.3v-5v; PCB size: 1.3 x 2.3 cm (QMC5883L size: 3.0 x 3.0 x 0.9 mm), with a16-pin leadless chip carrier (LCC)

Schematic

HMC2.jpg

Pin Function

  • VCC+5V - power pin, give it 3.3v-5VDC. For Arduino,recommand 5v
  • GND - ground pin
  • SDA and SCL - these are the I2C data and clock pins used to send and receive data from the module to your microcontroller. There are 10K pullups on these pins to the 3.3v pin. You can connect these pins to 5V I2C lines, there are level shifters on board to safely bring the pins down to 3V
  • DRDY - this it the 'data ready' pin output. If you want to stream data at high speed (higher than 100 times a second) you may want to listen to this pin for when data is ready to be read. Check the datasheet for more details about using the DRDY pin, we don't use it because we don't read that fast!

Test Experiment

1.Build the circuit

QMC5883L--------------- Uno/Mega2560
VCC------------------- 5V
GND------------------- GND
SCL------------------- A5/ pin21 mega2560
SDA------------------- A4/pin20 mega2560
DRDY------------------ N/C

Hmc3.jpg

2.Upload the code

1)Before you Upload the code ,you need to add the two library to the Arduino\libraries, Open IDE,click to Sketech -> Include library -> Add .ZIP Library

Hmc4.jpg

2)Find the QMC5883L.zip library, click to Open.
QMC5883L lib.png

3)Click to File -> Examples -> QMC5883L -> example -> QMC5883L_Compass

QMC5883L EXM.png

4)Select correct Board

Hmc7.jpg

And then correct Port

Hmc8.jpg

5)click the Upload icon to upload the code to the control board

Hmc9.jpg

6)Open the serial monitor, You will see stream of data with X Y Z magnetometer data in uTeslas,radians and degrees. If you hold the module so that it is parallel with the ground then it will point you in the direction of North! 

QMC5883L monitor.png

Resource

QMC5883L.zipZIP.jpg
QMC5883L-Datasheet.pdfPDF.jpg