Difference between revisions of "6D-BOX FAQ"
| Line 14: | Line 14: | ||
3. Connect the battery to any channel to power the receiver. When the red light indicator LED on the receiver blinks, it means they are binding now. <br> | 3. Connect the battery to any channel to power the receiver. When the red light indicator LED on the receiver blinks, it means they are binding now. <br> | ||
| − | 4. Press and hold the Binding (Key) on the transmitter and switch on the transmitter at the same time. | + | 4. Press and hold the Binding (Key) on the transmitter and switch on the transmitter at the same time.<br> |
| − | 5. If the red indicator stops blinking, it means the binding is done successfully. | + | 5. If the red indicator stops blinking, it means the binding is done successfully. <br> |
| − | 6. Then disconnect the power of the receiver. | + | 6. Then disconnect the power of the receiver. <br> |
| − | 7. Shut down the transmitter. | + | 7. Shut down the transmitter. <br> |
| − | 8. Connect the receiver and the flight control to check whether the binding is successful. If not, please take these steps again carefully to do it right. | + | 8. Connect the receiver and the flight control to check whether the binding is successful. If not, please take these steps again carefully to do it right.<br> |
Revision as of 07:07, 18 May 2017
Q1: How to Connect the Drone 6D-BOX and Receiver FlySky FS-iA6
Since the 6D-Box quadcopter kit does not include the receiver and radio transmitter, you may need some instructions on how to apply them with the kit. Here’s some guide on connecting the drone and receiver. (For more information, please refer to our user manual for the kit under LEARN.)
A: If the CH1 of your receiver is the leftmost and there are 1 to 7 channels, just insert the CH1 pin on the receiver into the No.7 pin header on the flight controller, CH2 to No.6 ,CH3 to No.5, Ch4 to No.4, CH5 to No.3, Ch6 to No.2 and CH7 to No.1 as shown below.
Note: B/VCC of the receiver is the channel for pairing and power input and will not function after connecting to the 6D-BOX.
Check the following instructions for using the B/VCC channel
The binding of the receiver with the transmitter is already done when it's manufactured. So you DO NOT need to bind again. But if you want to use them with other radio transmitters or receivers, then you need to re-bind. Please take the following steps before further operations:
1. Install the battery to the transmitter and shut it down.
2. Insert the binding cable into the B/VCC channel port of the receiver.
3. Connect the battery to any channel to power the receiver. When the red light indicator LED on the receiver blinks, it means they are binding now.
4. Press and hold the Binding (Key) on the transmitter and switch on the transmitter at the same time.
5. If the red indicator stops blinking, it means the binding is done successfully.
6. Then disconnect the power of the receiver.
7. Shut down the transmitter.
8. Connect the receiver and the flight control to check whether the binding is successful. If not, please take these steps again carefully to do it right.
