GY-33 Color Recognition Sensor Module

From Wiki
Revision as of 07:32, 16 September 2019 by Root (Talk | contribs) (Features)

Jump to: navigation, search

Introduction

GY-33 color recognition sensor module has these advantages: low cost, small volume, easy to mount, low-power consumption and its working voltage is 3~5V.
GY-33 01.jpg GY-33 02.jpg
TCS347525 GY-33 03.jpg
The TCS3472 device provides a digital return of red, green, blue (RGB), and clear light sensing values. An IR blocking filter, integrated on-chip and localized to the color sensing photodiodes, minimizes the IR spectral component of the incoming light and allows color measurements to be made accurately. The high sensitivity, wide dynamic range, and IR blocking filter make the TCS3472 an ideal color sensor solution for use under varying lighting conditions and through attenuating materials.

Features

  1. Measure Range: RGB 0~255;
  2. Frequency: 10 Hz;
  3. Working Voltage: 3~5V;
  4. Working Electric Current: 15mA;
  5. Working Temperature: -20° ~ 85°;
  6. Storage Temperature: -40° ~ 125°;
  7. Size: 24.3mm x 26.7mm;
  8. Sensor Chip: TCS34725.

Introduction of Pins

Pin Introduction
GND Connected to the cathode of the power supply
DR Serial port UART_RX/IIC_SDA
VCC Connected to the anode of the power supply(3v-5v)
NC Remain, do not connect to anything
INT TCS34725 color chip breaks off s1=0 (wiring up GND, run it)
SDA TCS34725 color chip data wire s1=0(wiring up GND, run it)
SCL TCS34725 clock line of color chip s1 = 0 (wiring up GND, run it)
S0 Serial/MCU_IIC Mode Choose
S1 Only let sensor chip choose