Difference between revisions of "Collision Switch Module"

From Wiki
Jump to: navigation, search
(Introduction of Pins)
(Introduction of Pins)
Line 15: Line 15:
 
</tr>
 
</tr>
 
<tr>
 
<tr>
<td></td>
+
<td>OUT</td>
 +
<td>VCC</td>
 +
<td>GND</td>
 
</tr>
 
</tr>
 
<tr>
 
<tr>
<td></td>
+
<td>Switching signal output</td>
 +
<td>positive pole</td>
 +
<td>negative pole</td>
 
</tr>
 
</tr>
 
</table>
 
</table>

Revision as of 08:10, 3 September 2019

Introduction

The Crash sensor is a miniature snap-action switch. It is also known as micro switch, an electric switch activated by a small physical force.
Collision Switch Module(front).pngCollision Switch Module(rear).png

feature

  • Special module with ports compatible with the expansion board of sensor.
  • Output low level when the module is activated; keep outputting high level at the state of release.
  • Applied in the detection of collision and touching impact.

Introduction of Pins

Introduction of Pins
OUT VCC GND
Switching signal output positive pole negative pole